Freshly painted white baseboards and door casing in a Vancouver home

Trim Painting

Trim & Baseboard Painting in Vancouver, BC

Trim is what your eye actually lands on. Baseboards, door casing, window frames, crown moulding and fascia all sit at human eye level and take constant abuse — vacuum hits, shoe scuffs, kid hands, weather. A proper trim repaint with the right urethane enamel transforms a tired room overnight and stands up for years.

Most trim repaints fail at the joint where trim meets the wall — gaps open up over time and the cut line ends up jagged and bleeding. We caulk every gap with a paintable acrylic, then hand-brush the cut line freehand so it stays sharp without tape. Done by an experienced painter, a freehand cut on baseboards and casing is sharper, faster and more reliable than tape.

Trim takes more abuse than walls so it needs harder paint. We use a urethane-acrylic enamel — Benjamin Moore Advance, Sherwin-Williams Emerald Urethane, or equivalent — which levels glass-smooth, cures rock-hard, and washes without burnishing. Two full coats over a properly sanded and primed base gives a finish that holds up for a decade.

Crown moulding, wainscoting and chair rail get the same systematic prep. Dark-stained original trim is sanded to break the sheen, then bonding primer goes down before topcoat — paint applied straight onto urethane varnish always chips around the handle of every door within a year. Exterior fascia, eaves and window trim are caulked, primed bare areas, and finished with an exterior-rated 100% acrylic.

  • Baseboards, casing, crown moulding, chair rail and wainscoting
  • Exterior fascia, window trim, eaves and soffits
  • Caulked at every joint where trim meets wall
  • Sanded to break original sheen, dings filled, primed where bare
  • Urethane-acrylic enamel — hard, washable, low-VOC
  • Hand brushed cut-line where trim meets wall — no tape bleed

Our Process

How we deliver trim projects

01

On-site quote

We measure trim length, identify problem areas (gaps, dings, dark stain), and write a fixed quote.

02

Mask & protect

Floors and walls protected, electrical and HVAC covered before any sanding starts.

03

Sand, fill, caulk

Trim sanded to break sheen, dings filled, every joint caulked clean and tight.

04

Prime & two coats enamel

Bare or stained spots primed, then two coats hand-brushed urethane-acrylic enamel.

05

Walkthrough & warranty

Every cut line and joint inspected, touch-ups completed, written workmanship warranty issued.

Local relevance

Built for Vancouver homes & weather

Vancouver homes have unusually generous trim — wide baseboards, tall casing, crown moulding throughout — especially in West Side character homes, Yaletown lofts and modern North Shore builds. Older heritage homes often still have original fir trim with decades of paint layers and dings to address. We know how to refresh both.

KitsilanoMount PleasantYaletownWest EndDunbarPoint GreyKerrisdaleMarpoleEast VancouverFairview
FAQ

Trim painting questions, answered

How much does trim painting cost in Vancouver?

Interior trim repaints typically run $2.50–$5.00 per linear foot depending on profile, original finish and prep needed. Most rooms are quoted by the room. Free written quotes after on-site visit.

Can you paint over dark-stained wood trim?

Yes. We sand to break the sheen, then prime with a bonding primer rated for slick urethane and oil-based finishes before two coats of a hard urethane-acrylic enamel — paint won't chip around door handles.

What paint do you use on trim?

Urethane-acrylic enamels — Benjamin Moore Advance, Sherwin-Williams Emerald Urethane Trim — which level glass-smooth, cure rock-hard, and wash without burnishing.

Do you tape or hand-cut the line where trim meets wall?

Hand-cut. An experienced painter's freehand cut is sharper, faster and more reliable than tape, which often bleeds or pulls finish off the wall.

Can you paint exterior fascia and window trim too?

Yes — we use exterior-rated 100% acrylic enamels on fascia, eaves, window trim and soffits, with caulk at every joint and primer over any bare wood or metal.

Is your work guaranteed?

Yes — every trim project is backed by our written workmanship warranty against peeling, chipping and cut-line failure.

Ready to transform your Vancouver home?

Get a free, no-obligation quote from Vancouver's most-trusted residential painters. Fast response, premium results.